Sensi Micro Frame V2

Drone Junkie
Sensi Frame V2
Earn 0 reward points
£0.00 £14.99
L
5+
In stock, ready to dispatch

Material

QTY:
Out Of Stock
Add To Wishlist

Sensi micro frame 
for fans of micro brushless flight.


Specially designed for 65mm props but you can use whatever you have to hand or just swap over your current brushless whoop.

I recommend 6000 - 8000KV 11xx sized motors if you do use 65mm props.
This frame is a collaboration between Drone Junkie and Ragge designs.

There is a great benefit to flying without restriction and proper balance.

I made a few small changes to the frame for this v2 version and added Mylar insulators and foam pads for feet and lipos. 

We currently do not have a canopy designed for the frame, we are working on one. 
I include a selection of bolts so you can use what suits your conversion best. 
Use the small foam pad under the frame to keep lipo in place with its elastic bands. 
The foam feet are included as is two Mylar shields. 

Package includes 

Sensi Frame (Carbon V2 or (HDPE original design V1))
Bag of hardware for fc and canopy mounting. 
1x Foam lipo pad
6x foot pads (3 of each orientation) 



This picture shows the correct forward direction (top = front) notice the rotated motor holes, this will lead the wires down the arms to the middle of the frame for plugging into motors. Shown below with lipo foam and foot pads in place. 
foams.jpg

The 4 inner mounting holes are the same as 65 and 75 frames so you can fit whatever fc you have from that series of drones. The outer 4 holes are the same as many 85 sized HD drones so if you wanted a HD Sensi there are many options for camera pods like these on Thingiverse






The item has been added to your basket

Continue Shopping
Proceed To Checkout