Want to make your own Brushless Whoop ?
This is the AIO to go for!
This is the Flight controller used in the Mobula7 HD.
You can also use this for your lightweight style builds.
Available in 3 variations, FrSky, DSMX & No receiver (to solder your own on).
We found this AIO to be the best in our Micro Brushless builds.
Technical Specifications:
Flight Controller:
MCU:STM32F411CEU6 (100MHZ, 512K FLASH)
Gyro Sensor: MPU-6000 (SPI connection)
Board size: 28.5 * 28.5MM
Power supply: 1-2S battery input (DC 3.5-7.4V)
Built-in 5A (each) Blheli_S 4in1 ESC Dshot600 ready ESC MCU Upgraded to EFM8BB21.
Frsky version Built-in SPI Frsky receiver with telemetry(D8/D16 switchable)
DSMX version Built-in Serial-based DSM2/DSMX compatible satellite receiver
No RX version support external serial-bus receiver like xm+, crossfire, S-FHSS and Dsm2/DSMX, Ibus protocol etc.
Built-in Betaflight OSD (SPI Control)
Built-in Current meter sensor Max up to 28A
Current meter scale set to 1175
Built-in 5V 1A Buck / Boost with LC filter
Built-in voltage detection
BLHELI_S pass-through Ready
Multi Serial port support
Fully compatible with almost Brushless whoop drone
Weight:4.3g
ESC:
MCU upgraded to EFM8BB21
Power supply: 1-2S LiPo/LiPo HV (3.5v/7.4v)
Current: 5A continuous peak 6A (3 seconds)
Support BLHeliSuite programmable
Factory firmware: S_H_50_REV16_7.Hex
Default protocol: DSHOT600
Receiver:
No RX version supports external serial-bus receivers like xm+, crossfire, S-FHSS and DSM2/DSMX, Ibus protocol etc.
FrySky version for International D8/D16 Transmitters.
DSMX version for DSMX/DSM2 Transmitters.
Firmware target:
Frsky version betaflight_4.0.0_CRAZYBEEF4FR.hex
Flysky version betaflight_4.0.0_CRAZYBEEF4FS.hex
DSM2/DSMX version betaflight_4.0.0_CRAZYBEEF4DX.hex
No RX version betaflight_4.0.0_CRAZYBEEF4DX.hex
Firmware download link
See Picture below for wiring:

More wiring diagrams :
No rx
Flysky
Frsky
DSMX
Package includes:
1 x CrazybeeF4 PRO flight controller
3 x Power cables
1 x Set of 4 Shock absorbing rubber mounts and screws